Machinists Carbide Cutter Lot of 12 Different Size Used
$40.00
This is a nice clean group of (12) carbide cutters, mostly single ended, a few double ended milling cutters. They range in condition from very good, to good useable condition, perfect for the home machinist. The biggest one is .75" shank, .715" cutting dia., good shape with a few tiny chips on the corners mostly. Next is a .500" shank, .500" cutting dia., a few small chips noted, overall very good as the chips are only on one of the 4 flutes. There are 4 .375" shank cutters, the 2 double ended are very good on one end only, both are .375" cutting dia.. There is two single ended .375 shank, the one without the protective covering is very good with a cutting dia. of ..325", and the one with the green coating on it is very good, with a .432" cutting diameter (this one may not be carbide, it is marked Fastcut CPM-T15 on the shank). Next is a .312" shank, double ended cutter, .31" cutting dia. good+ on one end only. Then another .312" shank, 4 fluted cutter with a .298" cutting diameter, good++ condition. There are (3) different .187" cutters, all in good useable conditon on the fluted area, small chips on the flute corners (not sharp as the should be, rounded slightly), the double ended on is good on one side only. Finally the smallest is .125 dia. shank, in very good condition, comes in the original tube. A nice used group of useable carbide cutters for your milling machine work!
